Specifications - Makita SP6000 Instruction Manual

ENGLISH (Original instructions)
1-1. Clamping screw
1-2. Blade lower limit stopper
2-1. Quick stop button
3-1. Quick stop button
4-1. Clamping screws
4-2. Tool base
5-1. Positive stopper
6-1. Lever
7-1. Bevel angle shifting lever
8-1. Base
8-2. Cutting line
9-1. Lock-off button

SPECIFICATIONS

Max. cutting depth
No load speed (min
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is specially intended for performing plunge cuts.
In addition, lengthways and crossways straight cuts and
mitre cuts with angles in wood can also be performed
while in firm contact with the workpiece.
If the tool is equipped with the special saw blade for
aluminium, the tool can be used for sawing aluminium.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB (A)
Wear ear protection
Explanation of general view
9-2. Switch trigger
10-1. Speed adjusting dial
11-1. Hex wrench
12-1. Lock-off button
12-2. Locking lever
13-1. Locking lever
14-1. Hex wrench
14-2. Shaft lock
15-1. Hex bolt
15-2. Outer flange
15-3. Saw blade
15-4. Inner flange
Model
Blade diameter
at 90°
at 45°
at 48°
-1
)
Overall length
Net weight
Safety class
) : 81 dB (A)
pA
) : 92 dB (A)
WA
ENE067-1
Vibration
The vibration
determined according to EN60745:
Work mode : cutting wood
Vibration emission (a
Uncertainty (K) : 1.5 m/s
ENF002-2
Work mode : cutting metal
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
ENG905-1
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
4
16-1. Vacuum cleaner
16-2. Dust port
18-1. Adjusting screws
19-1. Slide lever
20-1. Rip fence (Guide rule)
21-1. Rear edge of tool base
21-2. Fixed stop
23-1. Adjusting screw for 90 ﾟ
24-1. Adjusting screw for 45 ﾟ
25-1. Limit mark
26-1. Screwdriver
26-2. Brush holder cap
SP6000
165 mm
56 mm
40 mm
38 mm
2,000 - 5,800
341 mm
4.4 kg
/II
total value (tri-axial
2
) : 2.5 m/s
h,W
2
2
) : 2.5 m/s
h,M
2
ENG900-1
vector sum)
or less
or less
ENG901-1