Flexfire LEDs RGBW-CTRL-M8 User Manual

INTRODUCTION
The M8 remote control and receiver for RGBW LED strip lights uses the most advanced RF wireless transmission technology. The system consists
of 2 parts: the handheld remote control and the in-line receiver.
Featuring a fully programmable remote control which allows you to quickly choose red, green, blue or white, cycle through 6 preset colors, 6 preset
modes, create and save color schemes and alter the brightness of your strips. In addition, it includes a wall mount to easily place the remote control
on a nearby wall.
This unit is compatible with any of the Flexfire LEDs RGB+W LED strip light.
SAFETY AND WARNINGS
•
Install in accordance with the National Electric Code, and local regulations.
•
This product should be installed and serviced by a qualified electrician.
•
Do not connect directly to high voltage 120V AC power.
•
This product is rated for indoor installation and is not protected against moisture.
•
Proper heat dissipation will prolong the working lifespan of this product. Install in a well ventilated area.
•
Only install compatible LED drivers and fixtures. Contact Technical Support or visit the product page for compatible accessories.
•
Ensure applicable wire is installed between driver, fixture, and any controls in between. When choosing wire, factor in voltage drop, amperage
rating, and type (in-wall rated, wet location rated, etc). Inadequate wire installation could overheat wires and cause fire.
•
Utilize the wiring diagrams in this installation guide for basic setups.
RED GREEN BLUE
YELLOW PURPLE CYAN
JUMP3 FADE3 FLASH
JUMP7 FADE7 FLASH7
R G B
I I I
I 2 3
I I I
5 6 7
RF WIRELESS
R G BW- CT RL-M 8
COLOR CHANGING + WHITE M8
LED Remote Control & Receiver
Signal Indicator LED
On/Off Button
Color Shortcuts
6 Mode Auto Play
AUTO
Mode Shortcuts
B/S
Brightness/Speed
(color/mode shortcuts)
B/S
W
Custom Color Commands
(press and hold each color to dim)
I
4
Custom Color Save
I
Switch and Play
(switch or play saved colors 1-7)
support@FlexfireLEDs.com
RGB+W M8 Remote Control & Receiver

REMOTE CONTROL

Details
SKU:
Working Voltage:
Working Frequency:
Max. Signal Range:
Working Temp:
Dimensions:
Weight:
Warranty:
*Replace with CR2032 battery (Standard watch battery
**Comes with a wall mount for easy storage
925-273-9080 opt 2

User Guide

RGBW-CTRL-M8
3V (CR2032 battery)*
433.92MHz
130ft (40m)
-4°F ~ 131°F (-20°C ~ 55°C)
H: 4 1/4" (104mm) W: 2 5/16" (59mm)
D: 3/8" (9mm)**
1.48oz (42g)
5 years
from local hardware store)
1
page
V.2018.11.01