Low Power Sleep Mode; Battery Precautions; Care & Maintenance - TTS Bee-Bot User Manual

Low Power Sleep Mode

¥ If your Bee-Bot is not used for 2 minutes and the sensor switch is in the 'OFF' position,
Bee-Bot will play a sound and go into sleep mode.
¥ If your Bee-Bot is not used for 4 minutes and the sensor switch is in the 'ON' position,
Bee-Bot will play a sound and go into sleep mode.
¥ In sleep mode, very little power is consumed and the batteries will last a long time.
¥ Pressing any button in sleep mode, wakes Bee-Bot up, plays a sound and flashes the
eyes.

Battery Precautions

¥ Non-rechargeable batteries are not to be recharged.
¥ Rechargeable batteries are only to be charged under adult supervision.
¥ The supply terminals are not to be short-circuited.
¥ Regularly examine for damage to the plug, enclosure and other parts. In the event of
any damage, the toy and charger must not be used until the damage has been
repaired.
Care & Maintenance
¥ If necessary, wipe Bee-Bot gently with a clean damp cloth.
¥ Keep Bee-Bot away from direct sunlight and heat.
¥ Do not allow Bee-Bot to come into contact with water or other liquids. If painting or
gluing on the additional shells, ensure the shells are dry before clipping to Bee-Bot.
¥ In the event of a static discharge, Bee-Bot may malfunction. In this case, please
switch it off and then back on again to reset it.
¥ Bee-Bot is fitted with a DC 3.7V, 500mAh, Lithium Polymer battery
¥ The battery is located under a removable hatch held in place by a security screw. Using
the correct screwdriver, remove the hatch.
¥ The battery can now be disconnected. Only the correct replacement battery pack can
be used. Connect the new battery and carefully locate the battery in its compartment.
Being careful not to trap the wires, replace the battery hatch and secure with the screw
provided.