Recharging Bee-Bot - TTS Bee-Bot User Manual

Personalisation for command buttons
¥ The user can record 2 seconds of audio for each command simply by pressing the
command button for 2 seconds until a single beep is heard. When the double beep
is heard the record time has ended. Once recorded, audio will play back as the
command buttons are pressed and then again as Bee-Bot works its way through the
commands.
¥ To reset to the original function, simply press the clear button for 2 seconds until a
double beep is heard.
Clearing the Program
¥ When the memory in Bee-Bot is full, no more commands can be entered.
¥ Pressing the clear key <X> will clear the sequence memory.

Recharging Bee-Bot

¥ Insert the USB cable into the charging socket on the underneath of your Bee-Bot.
¥ Connect the other end to a spare USB port on a PC or laptop. Alternatively, connect to a
USB charging plug.
¥ If you have the Bee-Bot docking station, then place Bee-Bot into the docking station
and connect the power cable.
¥ Eyes flash red to show Bee-Bot battery is low and requires charging.
¥ Eyes light solid red to show Bee-Bot is charging.
¥ Eyes light solid green to show Bee-Bot is fully charged.
¥ It may take up to 2 hours to fully charge Bee-Bot if the battery has been fully
discharged.
¥ Once fully charged Bee-Bot will have approx. 6 hours of normal usage, approx.
1.5 hours when in continuous use.
¥ Please ensure your Bee-Bot is switched off to charge.
¥ To maximise battery performance, we recommend charging your Bee-Bot prior to use,
for the first time. We advise against leaving your Bee-Bot on continous charge,
therefore once the eyes turn white, please remove it from charge.
¥ To preserve Bee-Bot's battery, we recommend that you give your Bee-Bot at least one
full charge every 3 months, even if it hasn't been used.
Bee-Bot
TM