RAB Lighting WPLEDC104 Installation Instructions

WPLED104 INSTALLATION INSTRUCTIONS
Thank you for buying RAB lighting fixtures. Our goal is to design the best quality products to get the job done right. We'd like to hear your comments.
Call the Marketing Department at 888-RAB-1000 or email: marketing@rabweb.com
WPLED104
Standard (15 Deg)
IMPORTANT
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.
Fixtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper grounding is required
for safety. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON
FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
WARNING: Make certain power is OFF before installing or maintaining fixture. No user serviceable parts inside.
MOUNTING TO WALL
1. Orient Wall Mounting Box such that 'TOP' is pointing
up.
2. Feed supply wires through Gasket and Wall Mounting
Box.
3. Secure Wall Mounting Box to a sturdy wall. Use
appropriate mounting hardware such as lag bolts and
anchors with washers suitable for the mounting surface.
A Leveling Bubble is provided to level fixture.
4. Check that Gasket is fully sealed.
5. Slide the stainless steel Tether from the fixture into the
Key Hole Slot of the Clip for hands free wiring.
6. Wire the fixture using suitable wire connectors.
7. Place wired fixture over the Wall Mounting Box and
tighten the Top Screws. Now tighten the Lower
Screws.
8. Tighten Close Up Plugs and apply weatherproof
silicone sealant to all unused conduit entry points. Also
use sealant between the wall and Wall Mounting Box.
CLEANING & MAINTENANCE
CAUTION: Be sure fixture temperature is cool enough
to touch. Do not clean or maintain while fixture is
energized.
1. Clean glass lens & fixture with non-abrasive glass
cleaning solution.
2. Do not open fixture to clean the LED. Do not touch the
LED.
WPLEDC104
Cutoff (7.5 Deg)
Leveling
Bubble
Lower Screws
WPLEDFC104
Full Cutoff (0 Deg)
4.97
[126,3]
Key Hole Slot
4.58
[116,2]
Clip
1.30
[33]
Top Screws
Gasket
Tether
Wall Mounting
Box
Leveling
Bubble
4.97
4.58
[126,3]
[116,2]
Close Up
Plugs (4)
Gasket