7.7 Network selection control +PACSP
+PACSP
Modules
SARA-R410M-01B SARA-R410M-02B SARA-R410M-52B SARA-R412M
SARA-N4
Attributes
Syntax
full
7.7.1 Description
If the EF
(Customer Service Profile) is available the +PACSP URC is provided in the following cases:
CSP
•
SARA-R4 / SARA-N4 - at the module registration
•
SARA-R4 / SARA-N4 - whenever the SIM/USIM issues the REFRESH proactive command related to the
EF
CSP
For further information, see the AT&T Device Requirements [61].
The EF
is available on SIM/USIM cards from AT&T mobile network operator.
CSP
7.7.2 Syntax
Type
Syntax
Read
AT+PACSP?
URC
7.7.3 Defined values
Parameter
Type
<bit_value>
Number
7.7.4 Notes
•
If EF
is available, the PLMN mode bit forces the automatic network registration, according to the
CSP
+COPS
<mode> value which is loaded at boot from the selected profile (see the
following table explains the behavior:
Autoregistration <mode>
0
1
2
0
1
2
SARA-R4 / SARA-N4
•
The read command is not supported.
7.8 Channel and network environment description +UCGED
+UCGED
Modules
SARA-R410M-02B SARA-R410M-52B SARA-R412M
SARA-N4
Attributes
Syntax
partial
7.8.1 Description
Enables the protocol stack and network environment information collection.
UBX-17003787 - R09
PIN required
Settings saved Can be aborted
Yes
No
Response
+PACSP<bit_value>
OK
+PACSP<bit_value>
Description
PLMN mode bit value:
•
0: automatic network selection is forced (see Notes)
•
1: network selection mode unchanged (see Notes)
PLMN mode bit <bit_value>
0
0
0
1
1
1
PIN required
Settings saved Can be aborted
No
No
SARA-R4/N4 series - AT Commands Manual
Response time
No
-
Example
+PACSP1
OK
+PACSP0
Appendix B.1
Autoregistration behavior
Automatic network selection
Automatic network selection
Disabled
Automatic network selection
Manual network selection (search for the PLMN
stored in the selected profile)
Disabled
Response time
No
-
Error reference
+CME Error
and &V). The
Error reference
+CME Error
7 Network service
Page 49 of 307
Need help?
Do you have a question about the SARA-R4 Series and is the answer not in the manual?