ATI Technologies 3D CHARGER User Manual page 8

®
Windows "New Hardware Found"
If you are running Windows
after you restart your computer. Follow the step-by-step instructions below to
allow Windows
To identify new hardware in Windows
1 Windows
launching the "Update Device Driver Wizard".
If the wizard does not appear, proceed directly to
for Windows® 95 and Windows® 98
2 Click Next.
3 Click Finish.
4 Insert your Windows
5 Click OK.
6 Type the following:
D:\WIN95
(If D is not your CD-ROM drive, substitute D with the correct drive letter.)
7 Click OK.
8 Click Yes to restart your computer.
You are now ready to install your ATI enhanced drivers. Proceed to
Enhanced Drivers for Windows® 95 and Windows® 98
follow the step-by-step instructions to complete the installation.
To identify new hardware in Windows
After restarting your system, Windows
Hardware Found" dialog. Depending on your new hardware, you will either be
prompted to insert your Windows
the "Add New Hardware Wizard".
If Windows
click Yes to restart your computer when prompted; then proceed to
Enhanced Drivers for Windows® 95 and Windows® 98
To identify new hardware using Windows
1 Insert your Windows
2 Click OK.
3 Type the following:
D:\WIN98
(If D is not your CD-ROM drive, substitute D with the correct drive letter.)
4 Click OK.
5 Click Yes to restart your computer.
Getting Started...
®
95 or Windows
®
to correctly identify your new hardware.
®
95 briefly displays the "New Hardware Found" dialog before
®
95 CD-ROM into your CD-ROM drive.
®
98 automatically begins installing drivers for your new hardware,
®
98 CD-ROM.
®
98, new hardware may be detected
®
95
Installing Enhanced Drivers
on page 5.
®
98
®
98 will briefly display the "New
®
98 CD-ROM or Windows
®
98 CD-ROM
Installing
on page 5, and
®
98 will launch
Installing
on page 5.
4