ATI Technologies 3D CHARGER User Manual page 7

4
Grasp the new
card by the top
edge and
carefully seat it
into the
appropriate
expansion slot
(PCI or AGP).
Ensure that
the metal
contacts are
completely
pushed into
the slot.
5
6
Make sure all
cables are
securely
connected.
You are now ready to proceed with the installation of ATI's enhanced drivers.
For detailed instructions, select your operating system from the list below:
• Windows
• Windows
Getting Started...
If necessary, remove the metal cover from the empty expansion slot that
you select (PCI card use a PCI slot; AGP cards use an AGP slot); then
align your new card with the expansion slot, and press it in firmly
until the card is fully seated.
ATI 3D GRAPHICS CARD
(PCI OR AGP)
Replace the screw to fasten the card in place, and replace the
computer cover.
SCREW
ATI 3D
GRAPHICS CARD
Plug the display cable into your card; then turn on the computer and
display device. For cards with a Digital Flat Panel (DFP) connector,
connect your monitor or flat panel display (or both) to the appropriate
connector, as shown. Next, reboot your system.
DISPLAY CABLE
®
95/98, see Windows® "New Hardware Found"
®
NT, see page 6.
CORRESPONDING EXPANSION SLOT
TO VGA MONITOR
(ALL GRAPHICS CARDS)
TO FLAT PANEL DISPLAY
(DFP-READY CARDS ONLY)
on page 4.
3