Advertisement
Output Channel Configuration Page :
For output channel configuration, there are two analog output channel in
ADAM-6022. The output channel 0 is used as the control output for PID loop 0 and
channel 1 is for PID loop 1 when PID loop function is enabled. The configuration for
output channel is quite similar as input configuration. User can easily to finish the
configuration with the friendly operating interface of ADAM-6022 utility software.
Output Signal
Type Select
Analog Manual
Output Setting
ADAM-6022 can be a pure universal I/O module when PID being set in Free
mode.
User can use "Data Area" to setup the analog output to send a specific value
for such kind application. This function can also be controlled with MODBUS/TCP
protocol through Ethernet network for HMI/SCADA application.
For calibrating the analog output channel, user can use external certificated signal
measured device as calibrator then use the "Trim for 4mA" and "Trim for 20mA"
calibrating function to fine tuning the channel output signal for calibration
requirement.
Channel Calibration
Advertisement
