Tanks; Engine - Faria Beede MG3000 Installation & User Manual

Data Sources
Use DATA SOURCES to set the engine instance and to set or reset the maintenance
Ballast, Bait Well, Rudder, Fresh Water, Gray Water or Black Water.
Refer to your manufacturers Gauge Installation Guide of installation instructions for
2) Use the UP and/or DOWN buttons to select EDIT MENU.
3) Press and hold the MODE button to enter the selection.
4) Use the UP or DOWN buttons to select DATA SOURCES .
5) Press and hold the MODE button to enter the selection.

Tanks

The Tanks data source is where the source of the information that is received from a
analog (US 240-33, EU 10-180 Fuel Senders), or digital sources (Bus Data). To make
2) Press and hold the MODE button to enter the selection.
4) Press and hold the MODE button to enter the selection.
Note:

Engine

The Engine Data Source was set during initialization. If there is a need to change the
1) Use the UP and/or DOWN buttons to select ENGINE.
2) Press and hold the MODE button to enter the selection.
3) Use the UP or DOWN buttons to select ENGINE ID .
4) Press and hold the MODE button to enter the selection.
CSTM ALARMS
POP UP ALERTS
DATA SOURCES
TANKS
ENGINE
SPEED SOURCE
TANK SOURCE
T1: XXXXX
T2: XXXXX
T1: XXXX2
TANK 1 SOURCE
US 240-33
EU 10-180
BUS DATA - 0
SPEED SOURCE
STEERING ANGLE
Page 24