Connecting The Unit; Mounting And Placement; Connecting Power - ATTI Shadow Tracker Premier Hardware Manual

Vehicle tracking system
Hide thumbs Also See for Shadow Tracker Premier:
Table of Contents

Advertisement

C
ONNECTING THE

Mounting and Placement

Mounting devices used and the specific placement location of the Shadow
Tracker
Premier in the vehicle is left to the discretion of the end-user.
Note:
It is important, when considering the placement location for a unit, to
bear in mind that it is
required
Shadow Tracker
Premier) be kept at least 23 cm away from any nearby
persons in order to satisfy FCC RF exposure requirements

Connecting Power

The battery on the vehicle serves as the power source for the Shadow Tracker™
units however, if a unit is left on for an extended period in which the vehicle is not
running the unit may drain the vehicle battery to the point that the vehicle cannot
be started.
Carefully, connect the receiver adapter to the back of the Shadow Tracker
paying special attention not to bend any of the connector prongs.
The adapter should be connected to the vehicles power source.
Refer to: Wiring Instructions of this manual for further explanation.
U
NIT
that the transmit antenna (located inside the
3
unit

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Shadow Tracker Premier and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents