Cleaning And Maintenance - SATA Graph 1 Operating Instructions Manual

Operating Instructions SATAgraph 1
After loosening the paint needle quick tension (9) the paint needle (6) can be
pulled backwards out of the gun body (2).
The paint nozzle (5) is removed from the gun body (2) after screwing off the
air cap (4).
Pleas note:
The paint nozzle (6) is inserted only loosely into the air cap (5) - danger of
damage by dropping.
Assembly in the opposite sense:
After tightening the air cap (4) and the paint needle (6) is carefully pushed into
the gun body (2) towards the paint nozzle (5) at the front until bedstop and fixed
by tightening the paint needle quick tightening (10). Do neither cant the paint
nozzle (6) nor damage paint needle tip.
Attention:
Danger of hurting at the needle tip. When foreign parts are integrated the quality level may
decline and the SATA warranty expires.
Nozzle sets:
134619 0,25 for SATAgraph 1 (1 groove on paint needle, paint nozzle/air cap)
134635 0,45 for SATAgraph 1 (3 grooves on paint needle, paint nozzle/air cap)

5. Cleaning and Maintenance

Never use force. Using improper tools such as pipe wrench, gas torch, etc. will void any warranty.
In many cases proper repairs can only be carried out with the aid of special tools. In such cases,
limit yourself to establishing the cause of the problem and leave the repairs to the service depart-
ment. We refuse to accept liability for perfect functioning of the spray gun if it is disassembled by
the customer.
a) Clean airbrush paint spray gun during every color change.
b) Flush paint spray gun with water, airbrush cleaner or corresponding solvent. With
paints and lacquers having a high pigment content paint and lacquer remainders
quickly deposit on the needle and around the needle cap.
c) After finishing the work, thorough cleaning of the parts in contact with lacquer and
paint is required.
d) If possible, the integrated air piston unit (7) should not be dismantled.
Occasionally grease lever mechanism and needle in the area of the lever
mechanism with a thin layer of silicone-free gun grease (Order No. 48173).
Do not grease the needle tip and the area of air cap and paint nozzle!
II.4
2
6
9
4
5