Functional Description - SATA Graph 1 Operating Instructions Manual

Operating Instructions SATAgraph 1
1.2. Siphon cup version
• Gun with nozzle 0.25 (0,45)
• 5 ml siphon cup with lid
• Weight: approx. 100 g
• Operating pressure between 1.0 and 3.0
bars (14 to 43 psi)

2. Functional Description

The SATAgraph 1 is a „Double Action" airbrush paint spray gun allowing to control and to dose
compressed air supply and material flow independently from each other. By pushing the trigger
(1) the compressed air is released, and the compressed air volume is regulated. When pulling
back the trigger (1), the needle is pulled out of the paint nozzle, and material flow is released.
Dosage is effected by means of the trigger movement, depending on the paint needle (6) pre-
setting - see chapter 4.5. Different effects may be achieved in great variations by modifying the
air and paint flow.
1
The trigger is pushed and pulled
towards the back at the same
time. Thus, the needle is
pushed towards the back,
releasing the nozzle opening
for the paint flow.
2
By pushing down the trigger, the
air valve is opened. Compressed
air streams through the nozzle
and drags the paint along due to
the vacuum thus created.
Please note: Always keep the trigger under pressure during the entire painting procedure.
Heed the rule: „Start with compressed air, finish with compressed air !"
3. Construction
1 Trigger
2 Gun body
3 Gravity flow cup
4 Air cap
5 Paint nozzle (not visible)
II.2
• Recommanded un inlet pressure
2.5 bars (35 psi)
• Max. gun inlet pressure 4 bars
(58 psi)
6 Paint needle (not visible)
7 Air piston unit (not visible)
8 Air connection
9 Paint needle quick tightening (not visible)
10 End piece
1
2
Paint supply
Compressed air
Lever mechanism