PEUGEOT 3008 Handbook page 69

The electrical functions of the driver's
seat are active approximately one minute
after opening the front door. They are
deactivated approximately one minute
after the ignition is switched off and in
economy mode.
To reactivate them, switch on the ignition.
Before moving the seat backwards,
ensure that there is nothing that might
prevent the full travel of the seat, so
as to avoid the risk of of jamming the
seat caused by the presence of objects
on the floor behind the seat or rear
passengers. If the seat jams, stop the
movement immediately.
Head restraint height and
angle adjustment
 To raise the head restraint, pull it forwards
and upwards at the same time.
 To remove the head restraint, press the
lug A and pull the head restraint upwards.
 To put the head restraint back in place,
engage the head restraint stems in the
openings keeping them in line with the seat
back.
 To lower the head restraint, press the lug A
and the head restraint at the same time.
 To adjust the angle of the head restraint, tilt
its lower part forwards or rearwards.
Comfort
The head restraint is fitted with a frame
with notches which prevents it from
lowering; this is a safety device in case
of impact.
The adjustment is correct when the
upper edge of the head restraint is
level with the top of the head.
Before moving off, check the
adjustment of the head restraint; adjust
it if the seat has been occupied by
someone of different size.
Never drive with the head restraints
removed; they must be in place and
adjusted correctly.
3
67