Installation Instructions - Nielsen CT2142 Original Instructions Manual

CT2142
The following accessories are supplied in the shipping carton.
Fig.2
To assemble the heater, proceed as follows (see Fig. 2):
1、insert the wheel shaft J to the corresponding hole of feet pipe E，insert the cotter K to the
corresponding holes; put plain washer I to the two sides of shaft, slide the wheel H over the wheel
shaft J，screw the nut G to fix the wheel on the shaft.
2、Put the heater body on the feet pipe assembly, make sure the 4 holes of handle A point towards the
corresponding 4 holes on the feet pipe respectively.
3、Using the screw B ,spring washer C, plain washer C and nut 4 to fix the feet pipe assembly and
handle to the tank.

5. Installation Instructions

Position the heater on a flat, level, non-flammable, solid surface.
Direct-fired heaters are intended for use in outdoor open areas or in indoor well
ventilated areas. For indoor use, provide permanent ventilation openings of at least 25
cm²/kW, equally distributed between floor and high level, with a minimum of 250 cm².
•
Only install
upright position.
•
Do not place the heater near walls, corners or low ceilings.
•
Do not place the heater below a socket outlet.
•
Do not place the heater on moving vehicles or where it can tip over.
•
Keep the heater away from flammable, combustible, explosive or corrosive materials.
•
Keep the heater away from curtains or similar materials that could block the air inlet and
outlet.
•
Never block or restrict the air inlet and outlet for any reason.
•
Keep the power cable away from heat sources, sharp edges, cutting and moving parts.
•
Do not expose directly to the weather or to excessive humidity.
•
Do not place the heater in the immediate surroundings of a bath, shower or swimming
pool.
Minimum Opening Size
the
Pos. Description
A Handle
B Screw
C Spring washer
D Plain washer
E Feet pipe
F Nut M5
G Nut M12
H Wheel
I Plain washer ø12
J Wheel shaft
K Cotter
CT2142
800 cm²
Qty
1
6or8
6or8
6or8
1
6or8
2
2
2
1
2
heater in normal