Start-Up / Operation - NetterVibration AP 117 Operating Instructions Manual

AC/DC power supply

7 Start-up / Operation

In standby mode the red LED flashes. In the adjusting or operating mode
the LED lights when active keys are touched.
IMPORTANT
When switched on
DANGER
stored time values. The connected devices also start immediately.
AUTOMATIC
START
The sensor keys react to slight touching, not to pressing.
IMPORTANT
If, following a voltage interruption, power is again applied to the power
DANGER
supply connection, the next cycle will always begin with the set duty
time.
The output is immediately energized.
DANGER
AUTOMATIC
START
Terminal strips
Terminals 1-3
The voltage level of input
and output voltage is al-
ways the same.
AC/DC fuse
(1.25 A slow blow)
Output strip terminals 4-6
(AC or DC)
Power supply connection strip
terminals 1-3 (DC or AC)
Terminals 4-6
PE
the AP 117 starts immediately with the
12
AC/DC output