Table of Contents
Advertisement
1.3
STBLESensor app description
1.3.1
SensorTile module activation and transmission
When active (see
STBLESensor
To start transmitting data, the SensorTile module has to be virtually connected to the app by the scan procedure
described below.
Step 1.
Launch the STBLESensor app
Step 2.
Click on the Start Scanning icon
Step 3.
After a few seconds the app will show the SensorTile module device list identified by the scanning
procedure.
UM2260 - Rev 2
Section 1.4.1
Startup), the SensorTile module can transmit the environmental data to
app for smartphones and tablets.
Figure 3.
STBLESensor app - Start Scanning tab
UM2260
STBLESensor app description
page 4/25
Advertisement
Table of Contents
Need help?
Do you have a question about the SensorTile STEVAL-GPT001V1 and is the answer not in the manual?
Questions and answers