Install The Radar Processor - Navico MN000802A-G Installation Manual

NOTE: Use the bolts supplied as these are hardened stainless steel and the correct length.

4.10 Install the radar processor

Install the radar processor in a dry location away from spray, rain, drips, and condensation.
The location site must allow you to easily connect the radar processor to the ship's ground, the
interconnection cable, the power cable, and the radar communications cable or the network cable.
Check that these cables and the ship's ground can easily reach the radar processor BEFORE you
drill.
The radar processor dimensions are shown on the drilling template. Follow the instructions on the
drilling template to install the radar processor.