Advertisement
Do you have a question about the E-Tec 40 HP and is the answer not in the manual?
what should be included in a 90hp Evenrude Etech 2008 Outboard engine in a 300 hour check
A 300-hour check for a 2008 Evinrude E-Tec 90 HP outboard engine should include:- Engine monitor self-test and warning horn check - Emergency stop circuit and lanyard check - Controls, steering, and tilting operation check - Engine mounting hardware re-tightening (40 ft. lbs.) - Tighten any loosened fasteners - Water intake screens condition check - Cooling system and water pump indicator/water pressure check - Anticorrosion anodes condition check - Gearcase condition check - Propeller condition check - Inspect and repair fuel and oil system leaks - Check battery connections and condition - Access EMM information and resolve service codes - Inspect electrical and ignition wires for wear or chafing - Replace fuel filter - Replace oil filters - Replace gearcase lubricant - Inspect spark components (incomplete in the context, but likely spark plugs) Adjust maintenance frequency for rental, commercial, or high-hour use.
This answer is automatically generated
where is the trim/tilt relay located??
Need help?
Do you have a question about the E-Tec 40 HP and is the answer not in the manual?
Questions and answers
what should be included in a 90hp Evenrude Etech 2008 Outboard engine in a 300 hour check
A 300-hour check for a 2008 Evinrude E-Tec 90 HP outboard engine should include:
- Engine monitor self-test and warning horn check
- Emergency stop circuit and lanyard check
- Controls, steering, and tilting operation check
- Engine mounting hardware re-tightening (40 ft. lbs.)
- Tighten any loosened fasteners
- Water intake screens condition check
- Cooling system and water pump indicator/water pressure check
- Anticorrosion anodes condition check
- Gearcase condition check
- Propeller condition check
- Inspect and repair fuel and oil system leaks
- Check battery connections and condition
- Access EMM information and resolve service codes
- Inspect electrical and ignition wires for wear or chafing
- Replace fuel filter
- Replace oil filters
- Replace gearcase lubricant
- Inspect spark components (incomplete in the context, but likely spark plugs)
Adjust maintenance frequency for rental, commercial, or high-hour use.
This answer is automatically generated
where is the trim/tilt relay located??