Peavey DPE118P Operating Manual page 7

WARNINGS
CAUTIONS
The unit must be disconnected from the AC power source before any work is done on it.
Refer all servicing to qualified service personnel.
The back plate can become hot to he touch. Do not block or cover the fan opening from
ventilation. There must be a minimum of 4" of space behind the heat sink. Do not allow the
airflow to be become blocked by objects such as curtains or drapes, thermal building insulation,
etc. It is recommended that the rear of the DPE™ 118P Sub not be placed in a closed space or a
space that has no fresh, cool airflow.
DO NOT connect the inputs of the DPE™ 118P Sub to the output of a power amplifier. The
inputs are meant to be driven from a line-level signal.
DO NOT remove the protective metal grille.
WARNING!
The DPE™ 118P Sub is very efficient and powerful! This sound system can permanently damage
hearing!
Use extreme care setting the overall maxmium volume! The apparent sound level of the DPE™
118P Sub can be deceiving due to its clear, clean sound output. The lack of distortion or obvious
distress can make the sound level seem much lower than it actually is. This system is capable of
SPL in excess of 130 dB at 1 meter distance from the speaker!
CONNECTING AC POWER TO THE DPE™ 118P SUB
The DPE™ 118P Sub comes with a 6-foot IEC connection AC power cord. If you are using an
extension cord or power strip with this powered speaker, make sure it is of good quality and of
a sufficient current capacity to maintain safety and maximize the power output capability of the
DPE™ 118P Sub . For maximum undistorted output, do not connect any other device to the same
extension cord that the DPE™ 118P Sub is connected to Do not exceed the rated current capacity
of the extension cord with the sum total of all units connected to it.
When first plugging in the AC cord, make sure the power switch is in the Off position, and then
turn it On only once the power cord has been connected. Built-in muting will engage when the
proper sequence of steps is taken.
SPECIAL NOTE FOR PERMANENT INSTALLATION
When installing the DPE™ 118P Sub , AC power runs will be used and a certified electrician
should be consulted to be sure that all AC wiring complies with local codes and regulations. It is
also advisable to use a cable clip properly affixed to the cabinet to relieve strain on the IEC power
cord connected to the amplifier module at (3) so the power cord cannot be pulled out or vibrate
loose.