Crossover Frequency Control; High Pass Outputs - Peavey DPE118P Operating Manual

UPPER REAR PANEL

CROSSOVER FREQUENCY CONTROL

10
Varies the crossover frequency between the Subwoofer and the High Pass Outputs sent to the satellite/s speaker/s (11).
Varies the electrical crossover frequency from 90 Hz to 180 Hz.
CAUTION! SETTING THIS CONTROL TOO LOW MAY ALLOW THE SATELLITE SPEAKER TO BE
OVERLOADED BY DEEP BASS!
Setting the control lower DOES NOT increase the deep bass output of the DPE™118, a middle (straight up) to higher
setting works best for most speakers.

HIGH PASS OUTPUTS

11
These outputs provide a high-pass filtered signal to be fed to a full-range powered speaker system. Other full-range
powered speakers can be used, and full-range passive speakers can be used in conjunction with a suitable power amp
to drive them.
These outputs are electronically buffered and isolated from the input and from each other, and their level is not
affected by the DPE™118 Level control (8).
THRU FULL RANGE OUTPUT
12
This output provides a full-range signal to be sent to any other device that requires a full-range signal, such as another
DPE™118, or some other line level audio device. This output is electronically buffered and isolated from the input and
from the other outputs.
1 1