Advertisement
7.13Auto Live / Voltage Warning.
Should the leads be placed onto a live system before starting the
test, a warning beeper will be automatically activated and, the
instrument will display "Live Warning ..... Circuit Live ......."message.
Allow the instrument to discharge the circuit ( in the case of capacitive
system ) or make sure that the circuit under test is not live.
7.14Auto-Discharge.
At auto-stop or test completion, the instrument automatically
discharges the system under insulation test so that the dangerous
high voltage is discharged. The auto-discharge can be observed
on the L.C.D. so that the operator only removes the leads when the
discharge is completed. During discharge, a beep occurs so that the
user waits for the complete discharge of the system under test.This is
indicated by a one-second long beep accompanied by the
message on the display.DO NOT REMOVE LEADS UNTIL THE HOLD
MESSAGE
7.15"Replace Battery" Warning Indicator.
If the battery energy is detected to be too low, the instrument will
display the "Replace Battery" warning and automatically shut-down.
The instrument cannot operate properly with a low battery. Use only
Alkaline batteries.
16
APPEARS ON THE DISPLAY.
"HOLD"
Advertisement
