Advertisement
7.8 Voltage Output Bar-Graph.
The bar-graph displays the voltage present on the leads. It also
displays the voltage charging a cable or capacitive system under test
and displays the decay during the automatic capacitive discharge of
the system under test.
7.9 Auto-Low Resistance Detect.
While in insulation test mode and if the L.C.D. displays "LOW M",
stop the test immediately. This could mean that the insulation has
a breakdown, thus, you are now trying to inject a very high voltage
on a short circuit.
7.10Timer
The duration of the test is shown on the L.C.D. This is particularly
useful to verify that insulation does not break down within a certain
time.
7.11STOP Test.
To stop the test in progress, press the TEST button (1). The test will
immediately stop and the instrument will enable the ENER-SAVETM
mode automatically.
7.12Auto-Stop.
Should the operator leave the instrument in the test mode with the
ENER-SAVETM disabled, the instrument will automatically stop the
test after a duration of 99.9 seconds. ( Auto-off still applies. )
15
Advertisement
