Related Manuals for Clarke JSM200
Summary of Contents for Clarke JSM200
- Page 1 POWER PACK & JUMP STARTER MODEL NO: JSM200 PART NO: 6239000 OPERATION & MAINTENANCE INSTRUCTIONS ORIGINAL INSTRUCTIONS LS1117-ISS 1...
-
Page 2: Environmental Protection
INTRODUCTION Thank you for purchasing this CLARKE product. Before attempting to use this product, please read this manual thoroughly and follow the instructions carefully. In doing so you will ensure the safety of yourself and that of others around you, and you can look forward to your purchase giving you long and satisfactory service. -
Page 3: General Safety Rules
Do not operate the device if any of the cables are damaged. Consult your Clarke dealer for repair or replacement of the parts. Do not operate the device if the case is damaged. Consult your Clarke dealer or a qualified person for inspection and repair. -
Page 4: Electrical Connections
17. Never allow the jumpstart leads, to touch each other or to touch the same metal object. 18. Ensure the vehicle battery posts and battery clamps are perfectly clean before use. 19. Connect the red clamp to the unearthed battery terminal first, (this is usually the positive (+ve) terminal and coloured RED);... - Page 5 OVERVIEW DESCRIPTION NO DESCRIPTION On/Off Button USB Socket 5V DC Power Indicator Lights Charger Input Socket Worklight Jumpstart Lead Socket Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com...
-
Page 6: To Charge The Power Pack
TO CHARGE THE POWER PACK You can recharge the power pack using: • The mains charger (A) or • The cigar lighter adapter (B). 1. Switch the power pack off. 2. Plug the mains charger or cigar lighter adapter into the charger input socket 3. -
Page 7: Operation
OPERATION WORK LIGHT 1. Push and hold the ON/OFF button for 3 seconds to turn the work light 2. Push the ON/OFF button again. • The work light flashes on and off. 3. Push the ON/OFF button again. • The work light flashes with the morse code SOS pattern. -
Page 8: Jump Starting
JUMP STARTING WARNING: SOME VEHICLE ELECTRONIC EQUIPMENT MAY BE DAMAGED BY JUMP STARTING. ALWAYS CHECK WITH THE VEHICLE HANDBOOK WARNING: DO NOT USE ON DIESEL ENGINES. NOTE: This device will not jumpstart a vehicle if the battery is very low or completely flat. - Page 9 SMART CABLE STATUS LIGHTS STATUS Green LED Red LED Beeping Detecting Flashing Flashing Ready to start Solid Low Voltage Solid High Voltage Solid Short Circuit Flashing Reverse Polarity Flashing Reverse Charge Solid Solid Over heating Solid No operation within 30 seconds of connecting Solid Solid to the battery terminals...
-
Page 10: Declaration Of Conformity
DECLARATION OF CONFORMITY Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com...
Need help?
Do you have a question about the JSM200 and is the answer not in the manual?
Questions and answers