1. Manuals
  2. Brands
  3. Abocom Manuals
  4. Modem
  5. CAS1040
  6. User manual

Abocom CAS1040 User Manual

Ip sharing + fast etherswitch for cable / xdsl modem
Hide thumbs Also See for CAS1040:
Table of Contents

Advertisement

Quick Links

Download this manual
FCC Certifications
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
reasonable protection against harmful interference in a residential installation.
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation.
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
Shielded interface cables must be used in order to comply with emission limits.
You are cautioned that changes or modifications not expressly approved by the party
responsible for compliance could void your authority to operate the equipment.
This device complies with Part 15 of the FCC rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) This device
must accept any interference received, including interference that may cause undesired
operation.
CE Mark Warning
This is a Class B product. In a domestic environment, this product may cause radio
interference, in which case the user may be required to take adequate measures.
All trademarks and brand names are the property of their respective proprietors.
Specifications are subject to change without prior notification.
If this equipment does cause harmful interference to radio or
These limits are designed to provide
This

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CAS1040 and is the answer not in the manual?

Questions and answers

Related Manuals for Abocom CAS1040

Summary of Contents for Abocom CAS1040

  • Page 1 FCC Certifications This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio...

  • Page 3: Table Of Contents

    Table of Content INTRODUCTION ........................1 ......................2 AMPLE PPLICATION ..........................2 EATURES ..................... 3 ARTS AMES AND UNCTIONS ....................... 4 YSTEM EQUIREMENTS FACTORY DEFAULT SETTINGS ..................5 ..........................5 ASSWORD ................5 OCAL AND LOBAL DDRESSES ISP ....................... 5 NFORMATION FROM CONFIGURATION VIA GUI ....................
  • Page 4 ..........................35 TRACERT ..........................35 RELEASE ..........................36 RENEW ............................36 ..........................37 CONNECT ........................38 DISCONNECT ..........................38 STATUS ..........................39 VSERV ..........................39 ROUTE ..........................40 WANTEL ..........................40 UPGRADE FIRMWARE UPGRADE ....................42 ....................42 PGRADING THE FIRMWARE CHANGING PASSWORD ....................

  • Page 5: Introduction

    INTRODUCTION The BroadBand IP Gateway + Fast EtherSwitch is an integrated Internet IP sharing device with a built-in 4-port 10/100Mbps N-Way Fast Ethernet switch. It is the perfect solution to connect a small group of PCs to a high-speed broadband Internet connection. Multiple users can have high-speed Internet access simultaneously via one single IP address (Internet account) of the Cable/xDSL modem.

  • Page 6: Sample Application

    Sample Application Figure 1: Small Office/ Home Office Setup Features • For Internet connection. • Supports VPN (PPTP pass thru). - 2 -...

  • Page 7: Parts Names And Functions

    • Supports PPPoE. • Supports Internet applications such as Web, ICQ, FTP, Telnet, E-Mail, News, NetMeeting, PCAnyWhere, mIRC , CuSeeMe, AoE…etc. • Natural firewall keeps hackers out. • DHCP server allocates up to 128 client IP addresses. • DHCP client to get global IP address automatically. •...

  • Page 8: System Requirements

    connection; green with Green 100Mbps. (100M) Green Turns green when connecting to a Receiving/ Local 1 100Mbps Fast Ethernet /Orange Sending data Local 2 connection. Turns orange when connecting to Local 3 a 10Mbps Ethernet connection. Local 4 Have Mail Green N/A.

  • Page 9: Factory Default Settings

    FACTORY DEFAULT SETTINGS Password The default setting for password has been left blank in the factory. When using Telnet to configure the device, press Enter to login the configuration for the first time. It is recommended that you set a password for security and management purpose. If you forgot the password, you can reset the device to factory setting.

  • Page 10: Configuration Via Gui

    CONFIGURATION VIA GUI How to start 1. For the first time installation, insert the setup diskette in the floppy drive, in Windows, run setup.exe at the diskette’s root directory. Figure 3 2. After installing the setup program, go to Start Programs IP Share Setup.

Table of Contents