D-Link DWL-G710 Troubleshooting

Hide thumbs Also See for DWL-G710:

Troubleshooting - Can not access DWL-G710 on 192.168.0.30

Please note that when accessing the device's Web interface via http://192.168.0.30 you are not

accessing some web site on the Internet. The device's configuration pages are built into the

device. You do not have to be online to get to those pages, you just need to be connected to the

DWL-G710. Please also make sure all the Anti-virus/firewall software on your computer,

especially Norton, is disabled before you access http://192.168.0.30

Step 1.

Connect your computer's network

using a network cable.

Verify physical connectivity by checking for solid link lights on the LAN ports of the device. If

you do not get a solid link light, try using a different cable or connect to a different port on the

device if possible. If the computer is

Step 2. Under

Control Panel

is enabled and not bridged with any other connection. If you see any icon there

Connection

which is called "Bridge" - delete it. If you see your

right-click and select "Remove from Bridge".

DWL-G710 troubleshooting Page 1 of 5

port to your repeater's LAN ports (Ethernet ports)

to your computers

turned off, the link light may not be on.

Network Connections

Local Area Connection

... make sure that your

marked as "Bridged" -

Local Area

Table of Contents

Need help?

Do you have a question about the DWL-G710 and is the answer not in the manual?

Page 1 You do not have to be online to get to those pages, you just need to be connected to the DWL-G710. Please also make sure all the Anti-virus/firewall software on your computer, especially Norton, is disabled before you access http://192.168.0.30 Step 1.
Page 2 Step 3. Check your IP address. Your computer must have an IP address in the same range of the DWL-G710 static IP address: Set your computer with Go to > > > Control Panel Network Connections Local Area Connection Properties Select and click on Internet protocol TCP/IP Properties DWL-G710 troubleshooting Page 2 of 5...
Page 3 Subnet mask: 255.255.255.0 Default Gateway: 192.168.0.1 Preferred/Alternate DNS: 202.129.64.198 / 4.2.2.3 (o r whichever your provider is using). Click on and then again. Try to access the DWL-G710. Open Internet Explorer and type 192.168.0.30 DWL-G710 troubleshooting Page 3 of 5...
Page 4 Step 4. onfiguration pages, please reset the DWL-G710. If unsuccessful in accessing the device's c powered on, press and hold the Reset button for 10 Here is how to reset it: while the device is sec. Release the button and wait until the device boots up (1 min). Try to log into it again.
Page 5 Check the help files included with your firewall software for more information on disabling or configuring it. Step 7. If you still cannot log into the DWL-G710: - Recycle the power on the device. Switch the power off. Wait 20 to 30 seconds. Switch the power on and wait for the lights to stabilize.