Setup Options-Lighting Fixture Configuration; To Set The Dmx Start Address - PR LED Studio 3500T Manual

SETUP OPTIONS-LIGHTING FIXTURE CONFIGURATION

To browse through or change a fixture's configuration, after
AddR means the entrance of the menu. To set or browse through a fixture's settings, press buttons of UP and DOWN. After
button ENTER is pressed, a sub-menu is entered showing current parameters while indication flashing.
DOWN to change values(plus or minus)
Press button ENTER to save your settings or enter into the upper level menu and the indication stops from flashing.
Press FUNC to enter into the upper level menu(parameters not saved )or browse through the upper level menu.
After FUNC is pressed for more than 1second or buttons not pressed for more than 1 minute, it will go back to the main menu
displaying the fixture's name.
After the exit of the menus, the current lamp color will be shown.
While DMX signals are available, Signal LED indication will be on, otherwise off..
Each device must be given a DMX start address so that the correct lighting fixture responds to the correct control signals. This DMX
start address is the channel number from which the lighting fixture starts to "listen" to the digital control information being sent out
from the controller. The device has Two Channel Modes. 1 Channel Mode has 1 channel, so set the No. 1 lighting fixture's address
001, No. 2 lighting fixture's address 002, No. 3 lighting fixture's address 003, and so on. 4 Channel Mode has 4 channels, so set the No.
1 lighting fixture's address 001, No. 2 lighting fixture's address 005, No. 3 lighting fixture's address 009, and so on.
Launch the lighting fixture. Press button ENTER for more than 3 seconds to unlock the panel till
Press button FUNC, UP or DOWN to find "
Then press ENTER to show DMX address and press UP or DOWN to set DMX address.
At this time, the address will flash continuously. Press button ENTER to confirm and it means the setting has been
enabled and saved. After powered next time, the latest setting will be used.
Press button FUNC, it will return to the upper menu one by one.
ENTER button has been

TO SET THE DMX START ADDRESS

" menu.
6/12
pressed for about 3 seconds, the display of
Press button UP or
is displayed .