Schacht SPOOL RACK Assembly Instructions

SPOOL RACK
A
ssembly

PARTS

2 – bases
2 – uprights
1 – bottom brace
1 – center pivot
1 – top brace
67 60 36 0 30 0 100 10
10 67 72 10 84 4 0 28
Find out more at schachtspindle.com
Schacht Spindle Company 6101 Ben Place Boulder, CO 80301
p. 303.442.3212 f. 303.447.9273
© 2013 Schacht Spindle Company, Inc.
60 25 0 50 22 70 94 5
I
nstructIons

HARDWARE

2 – 3 1/2" truss-head machine screws
4 – 1 ¾" flat head machine screws
2 – 2 ½" truss head machine screws
8 – barrel nuts
10 – metal rods
10 – 1" Phillips head screws
01.13

ASSEMBLY

Assemble the bases to the uprights
1.
using (2) 3 1/2" truss-head machine
screws and (2) barrel nuts as shown
in the diagram.
Assemble the bottom brace to the
2.
bases using (2) 2 l/2" long machine
screws and (2) barrel nuts. Make sure
the notch in the center of the brace
faces up.
Install the ten metal rods into the
3.
holes in the center pivot so that the
bars extend evenly on each side. You
can rub the rods with bar soap to help
1 3/4"
screws
barrel
nuts
upright
holes for
1" Phillips
screws
barrel
nut
2 1/2"
screw
base
barrel nut
3 1/2"
screw
bottom brace
them slide in. When all the rods are
installed, secure each rod with one of
the 1" Phillips screws.
Place the center pivot with metal
4.
rods in position into the hole and
notch in the bottom brace.
Assemble the top brace to the
5.
uprights with the 1 3/4" long machine
screws and barrel nuts. Make sure
the center pivot hole faces down.
To turn the center pivot, simply lift
6.
and turn. The center pivot will lock it-
self in place when in its normal use.
1 3/4"
screws
top brace
steel bars
barrel nuts
upright
barrel nut
center pivot
barrel nut
2 1/2"
screw
base
3 1/2"
screw
•