Illustra Flex Series Quick Start Manual page 10

Procedure 1 Accessing the connector pins
Refer to Figure 9 on page 10 for a pictorial index of accessing the connector pins.
Step Action
1 Remove the two screws below (1) located on the top cover to open it.
Procedure 2 Connecting the wires
Step Action
This unit supports one of the following options as power supply:
1 Connect a power source:
a AC24V wired to connector and seperate RJ45 Ethernet.
OR
b PoE through RJ45 connector.
2 Connect any optional audio or digital inputs or outputs.
Note:The power source needs to be NEC Class 2 or LPS. The Indoor (PoE+ IEEE 802.3at or 24Vac)
and Outdoor (PoE Ultra 802.3bt or 24Vac) connections should be provided by a UL Listed product
and the connections shall be made in accordance with Article 800 of the NEC or local regulations.
10
Illustra Flex 2MP Indoor and Outdoor IR PTZ Dome Quick Start Guide
Figure 9 Accessing the connector pins
- End -
- End -
8200-1456-10 B0