Advertisement
WP1LED INSTALLATION INSTRUCTIONS
Thank you for buying RAB lighting fixtures. Our goal is to design the best quality products to get the job done right. We'd like to hear your comments.
Call the Marketing Department at 888-RAB-1000 or email: marketing@rabweb.com
ON-OFF WIRING
Universal voltage driver permits operation at 120V to
277VAC, 50 or 60 Hz.
1.
Connect the BLACK fixture lead to the (+) LINE supply
lead.
2. Connect the WHITE fixture lead to the (-) COMMON
supply lead.
3. Connect the bare copper Ground wire from fixture to
supply ground.
PHOTOCELL INSTALLATION
Photocell may be installed in the field. Apply weatherproof
silicone sealant to all plugs, around photocell and unused
conduit entries.
1. Remove close up plug on top of the wall mounting box.
2. Install photocell and wire as per diagram.
3. Use photocell rated for your supply voltage.
PHOTOCELL
Note: These instructions do not cover all details or variations in equipment nor do they provide for every possible situation during
installation, operation or maintenance.
Easy Installation & Product Help
Tech Help Line
©2015 RAB LIGHTING Inc.
Call our experts 888 RAB-1000
Northvale, New Jersey 07647 USA
WP1 LED -IN-0615
BLACK
LIGHT
"COM"
WP2FC
WHITE
FIXTURE
rabweb.com
Visit our website for product info
TROUBLESHOOTING
1. Check that the line voltage at the fixture is correct. Refer
to wiring directions.
2. Is the fixture grounded properly?
3. Be sure the photocell, if used, is functioning properly.
CLEANING & MAINTENANCE
CAUTION: Be sure fixture temperature is cool enough
to touch. Do not clean or maintain while fixture is
energized.
1. Clean lens with non-abrasive glass cleaning solution.
2. Do not open the fixture to clean the LED. Do not touch
the LED.
email
Answered promptly sales@rabweb.com
Advertisement
