ETELLIGENT
CONTROLLER
compatible
Installation
Product # 906612 Sun System
READ THESE INSTRUCTIONS BEFORE FIRING UP YOUR BALLAST
KEEP ORIGINAL PACKAGING:
avoid product damage during shipping. Any damage to products not in their original packaging
will not be covered under warranty.
SAFETY FIRST!
Failure to observe the following safety warnings may result in serious injury. In addition, failure to
observe these safety warnings will result in a waiver of all liabilities and will void all warranties.
WARNING:
If the exterior of the lamp is damaged, replace lamp immediately.
When relamping, make sure lamp has time to cool before touching.
Make sure power cord is connected properly.
Disconnect power before relamping.
DO NOT hang by power or lamp cord.
DO NOT make contact with the interior of the socket while power is on.
DO NOT operate light systems in wet locations.
D O NOT plug system into supply voltage other than what is designated on ballast.
D O NOT attempt to rewire or reconfigure your system, it will void warranty and could cause
serious safety hazards (i.e. power cord, lamp cord, lamp socket or ballast).
Keep away from children.
Sun System
1 Ballasts are controller-compatible
®
with signal ports for on /off /dimming functions
( Etelligent
controller sold separately. Part # 902245 )
™
Operating Instructions
&
1000 Watt DE Boss
®
All returns need to be in the original packaging in order to
1000 DE BOSS
®
COMMERCIAL FIXTURE
Includes hard-wired 277 volt
power cord with a L7-15p 277
volt twist lock power plug.
Commercial Fixture 277 Volt
®
Full warranty detail within.
®
Need help?
Do you have a question about the 1000 DE Boss and is the answer not in the manual?
Questions and answers