Transmitter Controls - ECX ECX13008 User Manual

EN
Reverse Switch
Allows you to change the direction of steering
(ST. REV) and throttle (TH. REV) controls (Ensure
proper function with a radio system test)
Throttle Dual Rate
Adjusts the maximum amount
throttle the model can be given
Steering Rate
Adjusts the amount the
front wheels move when the
steering wheel is turned left
or right
Binding is the process of programming the receiver to recognize the GUID
(Globally Unique Identifier) code of a single specific transmitter.
1. Power OFF the receiver and transmitter.
2. Connect a fully charged battery to the receiver.
3. Insert the bind plug into the receiver's binding pins and
power ON the receiver. The LED flashes.
4. Power ON the transmitter.
5. The LED turns solid when binding in successful.
1. Power ON the transmitter then the receiver.
2. Insert the bind plug onto the Failsafe pins.
The LED flashes rapidly for 2 seconds then turns solid when Failsafe is set.
3. Remove the bind plug.
2
TRANSMITTER CONTROLS
Power Switch
Power on or off the transmitter
Steering Wheel
Controls RIGHT
and LEFT
steering
Throttle Trigger
Controls power
to the motor for
forward or reverse
Forward Stop Reverse
BINDING
You must rebind when binding the receiver to a different transmitter.
NOTICE: Do not attempt to bind the transmitter and receiver if there
are other compatible transmitters in bind mode within 400 feet. Doing
so may result in unexpected binding.
FAILSAFE
Battery Level Indicator
Solid Red: Battery voltage is
good (above 4V)
Flashing Red: Battery voltage
is critically low (below 4V).
Replace transmitter batteries.
Throttle Trim
Adjusts the neutral point of
the electronic speed control
Steering Trim
Adjust to make the model
drive straight with no input
at the steering wheel