ECX ECX13008 User Manual

ECX13008 REPLACEMENT TRANSMITTER MANUAL
All instructions, warranties and other collateral documents are subject to change at the sole discretion of Horizon Hobby, LLC. For up-to-date product
literature, visit horizonhobby.com and click on the support tab for this product.
The following terms are used throughout the product literature to indicate various levels of potential harm when operating this product:
WARNING: Procedures, which if not properly followed, create the probability of property damage, collateral damage, and serious injury OR create a
high probability of superficial injury.
CAUTION: Procedures, which if not properly followed, create the probability of physical property damage AND a possibility of serious injury.
NOTICE: Procedures, which if not properly followed, create a possibility of physical property damage AND a little or no possibility of injury.
W ARNING: Read the ENTIRE instruction manual to become familiar with the features of the product before operating. Failure to operate the
product correctly can result in damage to the product, personal property and cause serious injury.
This is a sophisticated hobby product. It must be operated with caution and common sense and requires some basic mechanical ability. Failure to
operate this Product in a safe and responsible manner could result in injury or damage to the product or other property. This product is not intended for
use by children without direct adult supervision. Do not attempt disassembly, use with incompatible components or augment product in any way without
the approval of Horizon Hobby, LLC. This manual contains instructions for safety, operation and maintenance. It is essential to read and follow all the
instructions and warnings in the manual, prior to assembly, setup or use, in order to operate correctly and avoid damage or serious injury.
Age Recommendation: Not for children under 14 years. This is not a toy.
• Always ensure all batteries have been properly charged prior to using
the model.
• Always keep a safe distance in all directions around your model to
avoid collisions or injury. This model is controlled by a radio signal
subject to interference from many sources outside your control.
Interference can cause momentary loss of control.
• Never operate your model during adverse weather conditions. Poor
visibility can cause disorientation and loss of control of your model.
• Never install damaged batteries.
• Never install batteries of mixed types or of different ages in the
transmitter.
• Weight: 242g (377g with 4xAA batteries)
• Frequency: 2.4GHz
• Voltage/Capacity: 6V DC
This transmitter requires 4 AA batteries.
1. Remove the battery cover from the transmitter.
2. Install the batteries as shown.
3. Install the battery cover.
C AUTION: If using rechargeable batteries, charge only
rechargeable batteries. Charging non-rechargeable batteries
may cause the batteries to burst, resulting in injury to persons
and/or damage to property.
C AUTION: Risk of explosion if battery is replaced with an
incorrect type. Dispose of used batteries according to national
regulations.
MEANING OF SPECIAL LANGUAGE
SAFETY PRECAUTIONS
TRANSMITTER BATTERY SAFETY PRECAUTIONS

SPECIFICATIONS

INSTALLING TRANSMITTER BATTERIES
NOTICE
• Never point the transmitter antenna directly toward the model. The
radiation pattern from the tip of the antenna is inherently low.
• If at any time during the operation of your model you observe any
erratic or abnormal operation, immediately stop operation of your
model until the cause of the problem has been ascertained and
corrected.
• Always remove exhausted batteries.
• Always remove batteries before storing the transmitter.
• Low battery power can result in loss of control of the RC vehicle.
• Power Output: 120 meters
• Compatible Receivers: ECX13009
EN
1