MTU 20V4000Bx4 Operating Instructions Manual page 24

Installing the transport locking
device on driving end (KS)
Note: Install plate (6) on the upper part of the openings only.
1. Secure the plates (6) with screws (4) and washers (5) at the lateral openings on both sides of the flywheel
housing and tighten to the specified tightening torque.
Name
Screw
2. Screw locknut (2) onto screws (1) up to the end of the thread.
3. The long side of holder (3) must point downwards. Insert holder (3) through the openings of plate (6).
Note: Holder (3) must lock only the flywheel, not the ring gear.
4. Screw in screw (1) in bores of holder (3) until holder (3) is locked in position.
Note: Screw (1) must be tightened stepwise and alternately on both sides of the flywheel housing.
5. Tighten screw (1) to specified tightening torque.
Name
Screw
6. Install locknut (2) of screw (1) on plate (6) and tighten.
Removing the transport locking
device from driving end (KS)
1. Release the locknuts (2) on both sides of the
flywheel housing, remove screw (1) and take
off holder (3).
2. Remove screws (4) and take off with wash-
ers (5) and plates (6).
3. Store the removed parts of the transport
locking device carefully together with this
documentation for possible reuse.
22 | Transport | MS15039/01E 2018-11
Size Type
M16 Tightening torque
Size Type
M10 Tightening torque
Lubricant Value/Standard
(Engine oil) 250 nm +25 nm
Lubricant Value/Standard
(Engine oil) 30 Nm +3 Nm