Advertisement
4.
WIRED REMOTE CONTROLLER PARAMETER SETTINGS
1. Use the table below to change the parameters.
2. There are two code values "XY", the first code "X" means function, the second code "Y" means
detailed configuration of the function.
3. Setting method:
1.Simultaneously press and hold "Mode" and "Fan" buttons of the wired controller for 5 seconds to enter the parameter settings;
2.The value of this first code "X" is "0", press the temperature setting button
3.After setting the second code value, press
4.When the first code value is "6", press
Function
First code
Cool-only/ Cool-Heat
0
selection
2
Power-off memory
3
Filter cleaning reminding
Centigrade/Fahrenheit
6
display
3-pipe system/ 2-pipe
7
system
8
Setting ΔT value
CLIMATE 5000 VRF
button to switch the first code to the next value;
button again to exit the parameters setting.
0
Cool-Heat (Default)
Cool-only
Yes (Default)
None
Cancel the
1250 hours
reminding function
Centigrade
Fahrenheit
(Default)
3-pipe system
2-pipe system
(Default)
/
1°C
WIRED REMOTE CONTROLLER PARAMETER SETTINGS | 5
and
to adjust the second code value;
Second code
1
2
/
/
2500 hours
(Default)
/
/
2°C (Default)
3
4
/
/
/
/
5000 hours
10000 hours
/
/
/
/
3°C
4°C
6720863624 (2016/04)
Advertisement
