Zoning ZITY Quick Installation Manual
Zoning system
Hide thumbs
Also See for ZITY:
- Technical and installation manual (28 pages) ,
- Installation and service manual (24 pages)
Subscribe to Our Youtube Channel
Related Manuals for Zoning ZITY
Summary of Contents for Zoning ZITY
- Page 1 217741 ZITY zoning system Quick installation manual Technical Support Service: P.O. BOX 5 08540 Centelles (Barcelona) Tel. (+0034) 902 550 290 T +34 93 889 80 91 www.zoning.es...
-
Page 2: Table Of Contents
Frequency inhibitors and radio equipment operating in a permanent transmission mode in the same frequency band (433 MHz) may impair the normal operation of the ZONING. The system is designed to work on two different frequencies (433.92 and 434.33 MHz) to minimise this type of problem. -
Page 3: Technical Characteristics And Warranty
ZITY, quick installation guide (for air zoning installations) Technical characteristics and warranty ZEBRA Thermostat MADEL ATD hereby declares that the ZOE / ZEBRA / ZITY equipment complies with the essential requirements and • Power supply: 12 VDC any other applicable or enforceable provisions of Directives •... -
Page 4: Connection Of System Components
ZITY central control unit Connection of system components 1-A Direct expansion system with radio gateway Manual del usuario V 09/18... - Page 5 ZITY, quick installation guide (for air zoning installations) 1-B Direct expansion system with wired gateway 0.V 09/18 TAGBASE...
- Page 6 ZITY central control unit Fan-Coil system 2 and 4 pipes via radio Manual del usuario V 09/18...
- Page 7 ZITY, quick installation guide (for air zoning installations) Wired Fan-Coil system 2 and 4 pipes 0.V 09/18 TAGBASE...
-
Page 8: System Configuration
2 Connect the thermostats and the central control unit, via the following steps: • Locate on the front label the ID number (radio ID) of the ZITY central control unit and associate this number to each of the thermostats. Rx Tx... - Page 9 ZITY, quick installation guide (for air zoning installations) 2-B Configuration with ZEBRA thermostats (wired) 1 Configure the central control unit: select switch SW1 according to the diagram. There are two ZEBRA thermostat models: V1, 4-wire thermostat; V2: 7-wire thermostat. Direct expansion...
-
Page 10: Learning And Start-Up
3 Cut the voltage to the ZITY central control unit. 3.3 Start-up in normal operating mode ––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––– 1 Raise the voltage to the ZITY central control unit again. 2 When power is supplied to the central control unit it will begin to operate normally according to the configuration specified in the SW1. -
Page 11: Most Common Errors
ZITY, quick installation guide (for air zoning installations) Most common errors 4.1 For all installations ERROR INDICATOR CAUSE SOLUTION On supplying 230 VAC to No voltage or no • Check that voltage is reaching the ZITY the central control unit, no learning control unit (230VAC ±10%). - Page 12 Mode LED R7 in the row of relays Combined mode • Check the position of Switch 7 of the ZITY or is flashing error Active Modes of the ZEBRA thermostat. It is trying to make the central control unit work in Cold or Radiant Heat Mode.
Need help?
Do you have a question about the ZITY and is the answer not in the manual?
Questions and answers