Electrical Wire Connection - Thermador PH30HWS Installation Instructions Manual

In-line Blower
To minimize noise in the kitchen, these blowers are
mounted along the duct line anywhere between the
kitchen and the exterior wall. If there is easy access to duct
line (in an attic, for example), this may be an appealing
option.
inches (mm)
12⅛"
(308)
ø
9⅞"
(251)
Blower Wire Connection
1. Remove junction box channel covering the wires.
2. Remove circular knockouts.
3. Route the blower motor's plug connector to the hood.
Connect the blower's harness to the hood harness.
4. Route the blower harness through the self-locking
clip.

Electrical Wire Connection

1. Run a 120V AC, 15 amp circuit power cable from the
service panel through one of the holes in the top
plate. The VTR1330 blower in conjunction with a
PHxxGWS requires a 20 amp circuit breaker.
12"
(305)
⅞" (22)
19⅛"
(486)
1¾"
(44)
12⅞"
(327)
14⅜"
(365)
2. Connect black wire to power supply black wire, white
wire to power supply white wire and green wire to
green wire or bare wire.
Green to green
or bare wire
3. Place all wiring connections inside the junction box
channel. Reinstall on the top plate. Ensure that the
wires are secure and that no wires are pinched.
EXTNCB25W 25 ft. Remote and In-line
Blower Extension Cable (optional)
Parts Included
• 1 – 25ft cable
• 2 – Adapter Cables (NOT NEEDED for all models)
Blower Extension Cable Connection
The internal blower harness should be routed through the
knockout and secured with a 1'' (25.4 mm) strain relief.
The remote harness can then be connected to the blower
harness outside the unit.
NOTE: Cutting of the connector will void the warranty of
the appliance.
The blower extension cable is compatible with the
following In-line & Remote blowers:
Blower
Remote Blower
Remote Blower
Remote Blower
In-line Blower
In-line Blower
White to white
Black to black
SKU
VTR630
VTR1030
VTR1330
VTI610
VTI1010
Page. 19