Advertisement
nstructions
Step 2.
Floor Stand
1. Remove the floor stand from the shipping carton. No assembly is required.
2. Position the crusher on the stand lining up the four holes and secure with the
nuts and bolts provided.
Wall Bracket
1. Install wall bolts (not included).
2. Mount bracket to the wall.
3. Position the crusher on the wall bracket lining up the four holes and secure
with the nuts and bolts provided.
Step 3.
container
1. Thread the 1" x 4" drain fitting into the drain coupling on the underside of the
unit.
2. Push the 1" I.D. drain hose onto the fitting.
3. Position a catch container under the unit (not included). A 5-gallon bucket is
recommended.
Step 4.
connect air supply
1. Fill the lubricator bowl with SAE30 oil prior to installing the assembly on the
crusher.
2. Install the filter/regulator/lubricator assembly into the air inlet on the side of
the crusher.
3. Open the door to the crushing chamber prior to connecting the air supply.
4. Connect the air supply. It is recommended that the air regulator is to be set
at 85 psi but not to exceed 100 psi.
Step 5.
1. Place one filter in the crushing chamber with the open end of the filter facing
downward within the area surrounded by the six centering posts.
2. Close the door to activate the crushing cycle. When the unit stops running or
runs noticeable slower, the crushing cycle is complete. (Note - the crusher
will not operate with the door open.)
3. Raise the door and carefully remove the crushed filter.
Mounting Options
Install drain fitting hose and catch
Install the filter/regulator/lubricator and
Operation
Advertisement
