Advertisement
Checklist Of Components
Your filter crusher was shipped with the following components. Please be sure
you receive them as listed below. Contact us if anything is missing.
Item No.
1 ... ... ... ... ... ... ... ...Top Cover Guard ... ... ... ... ... ... ...1
2
... ... ... ... ... ... ...1" x 4" Drain Fitting
3
... ... ... ... ... ... ...1" x 1ft. Drain Hose
In addition, any air filter/regulator/lubricator is required in
order for the unit to operate properly. Item no. FRL-1 is avail-
able from JohnDow.
Good air quality is important for optimum performance
and life of the air/hydraulic pump. An inline air filter and
lubricator is required and must be maintained. Failure to
do so may result in damage to the unit and is not covered
Step 1.
REMOVE THE SHIPPING PLUG AND
INSTALL THE BREATHER CAP BEFORE OPERATION.
The shipping plug must be replaced with the breather cap before operating the
crusher. Failure to do so may result in damage.
The shipping plug is located on the top of the hydraulic fluid reservoir inside the
top of the aluminum cabinet.
1. Remove the cabinet top.
2. The shipping plug is located to the right rear of the cabinet. Remove the
shipping plug by turning it counterclockwise.
3. Install the breather cap turning it clockwise until finger tight.
4. Replace the cabinet top.
Description
IMPORTANT!
in the warranty.
Assembly In
... ... ... ... ... ...1
... ... ... ... ... ...1
Qty.
Advertisement
