Selecting Mode; Checking Current Parameters - ITS Telecom ITS-4.7HDP Installation Instructions Manual

5.2. Selecting mode

◎ Press ＂M＂to select heating mode.
Remarks: Except heating mode is available,
other modes are in valid.
5.3. Checking current parameter
◎ Under standby status or running status press ＂ ＂or＂ ＂ controller will display from Parameter 0
to Parameter 13 in turn with current value. See more in table on next page.
◎ In about 5 seconds display will return to standby or running status interface.
9