Color Kinetics eW Profile Powercore gen4 Installation Instructions page 4

8
Trim 3/8 in (10 mm) of insulation from the wires, and
attach wire nuts:
Line (L) Connector with black wire
Neutral (N) Connector with white wire
Ground (G) Connector with yellow/green wire
Package wires in the Switched Junction Box housing,
9
making sure not to pinch them, and replace the back
panel using the two Phillips-head screws.
Connect the Switched Junction Box to the eW Profile
10
Powercore luminaire at the end of the run. Use the two
mounting holes to secure the Switched Junction Box to
the mounting substrate with screws.
© 2018 Signify Holding. All rights reserved. Specifications are subject to
change without notice. No representation or warranty as to the accuracy
or completeness of the information included herein is given and any
liability for any action in reliance thereon is disclaimed. All trademarks
are owned by Signify Holding or their respective owners.
L N G
www.colorkinetics.com