Color Kinetics eW Profile Powercore gen4 Installation Instructions page 3

4 The Switched Junction Box has three knockouts for inserting
the power line — one on the end of the housing, and one
on either side. Using a flat-blade screwdriver, remove the
knockout that you want to use.
5 Remove the hex nut from the strain relief connector, and insert it into the slot behind the
selected knockout opening. Insert the ground connector strip into the tab to the left of the
knockout opening, so that the strip touches the hex nut.
6 Attach the strain relief connector to the hex nut, and tighten.
(The Phillips-head screws should be accessible when the
Switched Junction Box is installed. You may need to reposi-
tion the hex nut in its slot to properly orient the strain relief
connector screws.)
7 Insert the power line through the strain relief connector,
leaving enough wire inside the box to make connections.
Tighten the Phillips-head screws on the strain relief connector.
eW Profile Powercore gen4, Switched Junction Box Installation Instructions 3