Page 1
INSTALLATION GUIDE Installing the hardware. The ACTIVote transceiver is installed by simply plugging the 25 pin connector into the slot provided on the upper surface of the ACTIVboard electronics pod. This is behind the upper left corner of the board.
Page 2
TP1397 PRM-AVOTE-UPGRADE Installation instructions TP1397 PRM-AVOTE-UPGRADE Installation instructions A) Most computers are set up to boot from a floppy disk prior to booting B) If the BIOS of the PC is not configured to boot from the floppy then from the hard disk drive. If the computer BIOS is configured to boot from either: The BIOS can be changed to boot from the floppy or the program the floppy drive then: can be launched from within windows...
Need help?
Do you have a question about the ACTIVote and is the answer not in the manual?
Questions and answers