Hapton Bay MARLOWE Use And Care Manual page 12

Assembly - Attaching the Light Kit
12
Attaching the light kit pan
CAUTION: To reduce the risk of electric shock, disconnect
the electrical supply circuit to the fan before installing the
light kit.
□
Remove one screw (N) from the black bracket below the
fan-motor assembly (E). Loosen, but do not remove the
other two screws.
□
Attach the light kit pan (F) to the fan-motor assembly (E)
by securing them with the two screws (N) loosened in the
first step. Push the light kit pan (F) up to engage the screw
heads in the screw slots and turn to secure. Re-install the
screw (N) removed in the first step. Tighten each screw
firmly.
N
14
Installing the light bulbs and
glass bowl
WARNING: Do not overtighten when installing the glass shade
into the light kit assembly. Allow the glass shade to cool
completely before removing.
□
With the power off, install the light bulbs (L) (Max. 14W,
provided) into the light bulb sockets.
□
Remove the finial (PP), hex nut (QQ), and rubber washer (RR)
from the threaded nipple (SS) of light kit fitter assembly (I).
Place the threaded nipple through the centre hole of the glass
bowl (J). Re-install the rubber washer (RR), hex nut (QQ), and
finial (PP).
13
□
□
□
□
E
F
12
Attaching the light kit
Remove one screw (P) from the light kit pan (F). Loosen, but
do not remove the other two screws.
Connect the blue wire exiting the bottom of the fan-motor
assembly (E) with the black wire from the top of the light kit
fitter assembly (I).
Connect the white wire exiting the bottom of the fan-motor
assembly (E) with the white wire from the top of the light kit
fitter assembly (I).
Attach the light kit fitter (I) to the light kit pan (F) by securing
them with the two screws (P) loosened in the first step. Push
the light kit fitter assembly (I) up to engage the screw heads
in the screw slots and turn to secure. Re-install the screw (P)
removed in the first step. Tighten each screw firmly.
E
P
SS
F
I
I
L
J
RR
QQ
PP