Boot Mode - Cisco MWA1221 User Manual

Boot Mode

The MWA1221 product supports the Boot Mode process as illustrated in the following figure:
The MWA1221 would be in Boot Mode when power is first applied or a reboot/restart of code image has occurred.
The MWA1221 supports maximum two code image stored within flash. The execution options are:
a) It would attempt to execute and run the existing code image if only a single code image is stored within
flash
b) It would attempt to execute and run the current code image if a current and a previous code image are
stored within flash
c) It would execute and run the previous code image if the APS fails to execute and run the current code
image and when both a current and previous code image are stored within flash.
The MWA1221 would transition to Connect Mode if the code image successfully executes and runs.