MEI CashFlow 130 Quick Reference Manual

Teaching a New Token
The following procedure must be followed in order to
teach a new token into channel 1.
NOTE:- Rotary data switch position "E" is used to
program tight window token limits and ' F' standard
window token limits.
Switch the power to the validator.
OFF
1.
Set the 4 way
DIL
2.
& (channel 1) or OFF, ON & ON
ON, ON OFF
for (channel 0)
Set rotary data switch to position " F"
3.
standard window limit.
Switch the power to the product.
ON
4.
(The will start flashing).
LED
Insert 10 to 20 (minimum 10) of the desired
5.
tokens through the validator.
Return the 4 way
6.
Normal Operation settings.
( will stop flashing and stay
LED
success).
If the continues to flash
LED
of times this indicates a failure to teach the
new token. See
LED
for help and then restart procedure again.
Token is now programmed and ready to use.
7.
(New token information has been stored in
coin channel " 1" which is rotary switch position
" 1" ). Any previous taught token information
in this channel will be overwritten).
NOTE:- If token self teach is successful but token
taught is rejected i.e. gives 3 flashes of the
check that channel "1" is enabled.
To enable the new token set the rotary data switch
to position "1" then refer to enabling coin or tokens
configuration procedure).
MEI,
Internet: http://www.meigroup.com
teach switches 2, 3 & 4 to
switches 2, 3 & 4 to
DIL
to indicate
ON
a number
OFF
Assistance Codes table
LED,
CashFlow
Quick Reference Guide
Applies to Product Version G1
Typical coin set label
Internet:http://www.meiglobal.com
Data Switch
Channel
Affected
Position
0 0
1 1
2 2
3 3
4 4
5 5
6 6
7 7
8 8
9 9
A 10
B 11
C 12
D 13
E 14
F 15
27364 G2
® 130
R
¨
RGB001HA0103
Green Diagnostic
LED
Rotary Configuration
Switches
Coin Coin Coin
Type Output Enabled
Token 1 B
Token 2 B
5p -
10p C
20p D
50p old
50p new E
50p new
£1
F
£1
£2 Tight
£2 Tight A
£2
- -
- -
- -
719550044
No
Yes
No
Yes
Yes
No
Yes
Yes
Yes
Yes
Yes
Yes
Yes