Honeywell EVCS-CMPT9 Installation, Commissioning And Maintenance Manual page 19

Panel Test
This menu option performs various tests on the panel in line with BS5839 pt 9 2011.
Panel test
There are four sub menus.
Back
>Battery test
Define outstation
Outstation ring
Test indicators
Battery Test
This menu option performs a battery test when requested. The menu shows the current state of the PSU and the battery. Both the
battery present test and the battery high impedance test are performed automatically (every 15 seconds, and every 3 hours
respectively). However, this menu allows both battery tests to be performed on demand. Typically this is performed when the
Battery test
batteries have just been added or changed.
Mains: OK
Batt : OK
Action>Quit
Press up or down to toggle between Quit and Retest. Press TICK to select that action.
Define Outstation
This menu option will set all outstations to present. This does not permanently save all outstations as present. This is used for
Define all handsets
testing purposes only.
Master>No
Slave:No
:Next
Outstation Ring
This menu option will cause all outstations to ring, for single engineer testing of a system. When an outstation is picked up it is
Define all handsets
recorded in the call log.
Master>Start
Slave:No
:Next
Test indicators
Test indicators
This menu will sound the buzzer, and will flash all panel LEDs, except for the green power LED.
>Quit
www.acornfiresecurity.com
18
www.acornfiresecurity.com