Table of Contents
Advertisement
P73261/F5U206-MAC/US/man.qxd
Digitizing Clips using Strata
on the USB VideoBus
with the "Show Digitizing Window" command. The
digitized clips will be stored in the VideoShop
folder (or designated digitizing folder). To use the clips,
import them into the bin when you start a project.
3.
The "Project Settings" dialog appears. Click on the
"Internet" setting. Both the "Recording" and "Project
Settings" change to "Width: 160", "Height: 120" and
"FPS: 15". This means that the clip you digitize will be 160
pixels wide x 120 pixels high. Your VideoShop
also have the same settings and have a frame rate of 15
frames per second.
4.
Click "OK" to start a new project with these settings. A
new project starts and VideoShop
5.
Select "Show Digitizing Window" from the "Windows" menu.
Click the "Digitize" button on the button bar (icon that
looks like a video camcorder located on the upper right-
hand corner of your screen). The "Digitizing" window is
displayed. The size of the digitizing area is displayed at the
top left: 160x120.
To Configure the Digitizing Software:
1.
From the "Digitize" menu, select "Video On" to enable
the Video digitizing function.
Note:
This command is only enabled if VideoShop
a digitizing card in your computer (in our case it is the
USB VideoBus
A check mark next to the command indicates it's
already active.
2.
From the Digitizing menu, select "Video Settings". The
"Video" dialog box appears.
3.
From the "Video Settings" pop-up menu (top left) select
"Source". This option is used to select the source for
1/7/00
5:23 PM
™
VideoShop
™
(continued)
™
™
's main windows appear.
-OR-
™
).
8
Page 8
™
4.5
™
cache
project will
detects
™
Advertisement
Table of Contents
