Table of Contents
Advertisement
5. INSTALLATION
To install an eMCONTROL1 unit, follow these steps:
Installation of a single unit recessed or surface mounted:
1. Remove the front panel cover held by magnets. You can use the magnet
provided as a tool to make contact in the upper right-hand corner of the
cover and gently pull on it.
2. Connect the RJ-45 connector of the CAT5 cable or better to one of the
REMOTE inputs of the eMIMO1616. If necessary (see note below),
connect an external power supply.
3. Screw the device to the surface mount box or flush mount box.
4. Put the front panel back in place and secure the rotary encoder knob.
Installation of an eMCONTROL1 unit next to a WPaMIX-T wall panel, recessed or
surface mounted:
Note: a WPa2FMBOX double installation box is required to flush mount the two
devices side by side. Otherwise, for surface mounting, a WPa2SMBOX dual box is
required. Both WPa2FMBOX and WPa2SMBOX are sold separately.
1. Remove the front panel covers held by magnets on both devices
(eMCONTROL1 and WPaMIX-T). You can use the magnet provided as a
tool to make contact in the upper right-hand corner of the cover and
gently pull on it.
2. Mount both devices in the WPa2SMBOX or WPa2FMBOX frame.
WPaMIX-T is mounted ON the frame, while eMCONTROL1 is mounted
BEHIND the frame.
3. Connect the RJ-45 connector of the CAT5 cable or better to one of the
REMOTE inputs of the eMIMO1616. If necessary (see note below),
connect an external power supply.
4. Interconnect both devices (eMCONTROL1 and WPaMIX-T) with the
supplied cable. See Figure 1.
5. Screw the device to the surface mount box or flush mount box.
6. Put the front panels back in place and secure the rotary encoder knob.
6
Advertisement
Table of Contents
