Makita DSC102 Instruction Manual page 11

ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
Installing the cutting dice
CAUTION:
Always install the cutting dice in
the correct directions and secured firmly. Incorrect
or loose attachment may cause breakage of the
cutting dice, resulting personal injury by flown off
fractions.
NOTICE:
Remove the burr on the cutting dice
using a file if any.
1. Check if the jaw of the cutting dice is fully opened.
If not, install the battery and pull the switch trigger until
the jaw is fully opened.
CAUTION:
Be sure to remove the battery
cartridge if you installed.
2. Set the reversing switch lever to the lock position.
► 1 . Reversing switch lever
3. Unscrew the bolts with the supplied hex wrench.
CAUTION:
Use only the Makita wrench pro-
vided with the tool. Using other wrenches may
result in overtightening or insufficient tightening which
causes personal injury.
4. Set the cutting dice onto the mounts so that the
two colored markings can be seen.
2
5
► 1 . Bolt 2. Cutting die 3. Stationary mount 4. Movable
mount 5. Colored marking 6. Hex wrench
5.
Secure the cutting dice with the bolts firmly.
The cutting dice are correctly installed if the arrows on
them point each other. The dimensions of the cutting
dice are the same but their thickness look different
when seen from above.
1
3
► 1 . Arrow 2. Cutting die 3. Thin side 4. Thick side
11 ENGLISH
3
1
6
1
2
1
2
4
4